CruzPro Rudder Indicator

Home
Computers
Monitors
Products
CruzPro
Whats New?
Nobeltec
RADARpc
C-Wiz
Wind Gauge
Contact Us

New Website

 

.

CruzPro AM30 Digital Rudder Angle Indicator with built-in alarms

 


CruzPro AM30 Digital Rudder Angle Indicator



CE Certified

Waterproof front case

Specifications

Operating Voltage:
9.5 - 33.0 VDC.
Current Drain:
0.030 amps nominal.
Display:
4 digit LCD, 5 levels of backlighting.
Data:
Rudder Angle: -90 to +90 degrees
Port and Starboard.
Connect as Master or Slave.
NMEA 0183 serial data output.
Standard $IIRSA sentence.
Alarms:
Independent Port and Starboard
built-in 85 dB audible alarms
for excess rudder angle.
Programmable External Alarm output.
Size:
2.5" dia X 4.1" deep (61mm x 104mm)
Mounting:
2-1/8" (55mm) round hole.

 

CruzPro AM30

The AM-30 provides an accurate single sensor rudder angle indicator. Rudder angle is displayed in full units between -90 and +90 degrees. Separate alarm limits can be set for port and starboard.

The AM-30 provides for sender calibration and zero (rudder center) set.

The rudder angle is output on a NMEA 0183 compatible serial data line. This ASCII information can be used to log performance, repeat the display information at a remote location  or for use with the CruzPro SEAviz virtual instrumentation software running under Windows on your computer (see . If NMEA 0183 serial data is not required, then the output terminal can be programmed as an external alarm output pin.

Independent Port and Starboard rudder angle limit alarms can be set. When activated, the built-in 85 dB alarm will sound and the display will flash.

Five levels of backlighting can be selected for night-time viewing and all set-up, calibration constants and alarm values are saved to non-volatile memory.

The AM-30 can be operated from a 9.5 to 33.0 VDC power supply.

The AM30 works with all standard rudder angle sensors and can be connected as either a master or slave.

AM30 Simple Connection Diagram


AM30 Simple Connection Diagram