- ***
NEW *** SB2 Dual Sender Buffer
Keep your existing analog gauge and single station sender and add a
CruzPro digital gauge with the SB2 Dual Sender Buffer. Each SB2 will
buffer two separate senders and has separate calibration adjustment
potentiometers for each sender.
|
- T30
/ T60 Digital Water Temperature Gauge. Built-in settable high
and low temperature alarms. Very accurate and works with all popular
senders (VDO, Teleflex, Stewart-Warner, etc.). Handles both 12 and 24
Volts. 5 levels of backlighting, displays degrees C or F, NMEA 0183
output.
|
- OP30
/ OP60 Digital Oil Pressure Gauge. Built-in settable high and
low oil pressure alarms. Very accurate and works with all popular oil
pressure senders (VDO, Teleflex, Stewart Warner, etc.). Handles both
12 and 24 Volts. 5 levels of backlighting, displays PSI. or BARS, NMEA
0183 output.
|
- ***
NEW *** RH110 RPM, Engine Hours Gauge
Digital RPM, Engine Hours, Elapsed Time Gauge. Accurate to 1 RPM.
Displays elapsed trip time and total engine hours. Set maintenance
alarms to remind you when to change oil, etc. 5 levels of
backlighting, NMEA 0183 output.
|
|
|
- ETM20
Engine/Exhaust Temperature Monitors. The ETM-20 Engine/Exhaust
Temperature Monitor and Alarm uses modern electronics and a reliable
solid state temperature sensor to accurately monitor the temperature
at any point it is attached. The alarm is factory pre-set at 90
degrees C (194 deg F) but can be easily adjusted with a small
screwdriver over a range of 50 deg C to 125 deg C (122 to 257 deg F).
When the ETM-20 detects an over-temperature condition it sounds a
built-in 85 dB audible alarm.
|
|
|
- PY30
/ PY60 Digital Pyrometer/Exhaust Temperature Monitors. The
PY30 Digital Pyrometer and Alarm is a four-digit LCD display of engine
exhaust gas temperature up to 2000 deg F (1100 deg C). High and Low
alarms can be set over the entire range of the instrument. When the
PY30 detects an over or under temperature condition it sounds a
built-in 85 dB audible alarm.
|
